Netgear ReadyNAS 20+4-Pin PSU - Fan Position Explained

This short video explains why the cooling fan on our replacement Netgear ReadyNAS 20+4-pin power supply sits at the opposite end to the original, and why that is completely normal. This applies to our 20-pin + 4-pin ReadyNAS power supply only; our 20-pin-only ReadyNAS power supply is a different unit and is not affected.

On the original ReadyNAS power supply, the fan sits next to the power socket, behind a metal air duct, and pushes the hot air out through the duct and the vent at the back of the NAS. On our replacement, the fan sits at the other end, next to the cables, and pulls cool air through the whole unit before pushing it out through the grille next to the power socket. The air flows in exactly the same direction, through the same duct and out of the same vent, so your NAS stays just as cool.

Important: our power supply is supplied without the metal air duct. Remove the duct from your old power supply and fit it on the new one, on the power inlet side over the grille, not on the fan side.

The replacement is a brand new FSP 270W unit, 80 Plus Bronze with Active PFC, with the same size, the same screw holes and the same proprietary 20-pin and 4-pin connectors as the original DPS-200PB-186A. It fits the ReadyNAS 300, 400, 500, 600 and 700 Series, including the RN316, RN428, RN516, RN526, RN626X, RN628X and RN716X. Not sure it is the right power supply for your NAS? See the full compatibility list on the product page, or contact us with your model number and a photo.